3W RGB Laser Projector / My Ray X3 Technical Parameters:

Power Rated: 190~240V 50~60Hz (±5%)
Consumption: Max.150VA
Total optical output: 3.1W
Laser module:
637nm 680mW KVANT
520nm 900mW KVANT
445nm 1600mW KVANT
Beam diameter: 3.5x4.5mm
Divergence: <0.8mrad
Modulation: 0-5V analog, up to 100kHz TTL
Scanner set:DT-30 30Kpps Max.60Deg
Input connector: ILDA IN DB25 male
Output connector: ILDA OUT DB25 female
Operation temperature: 0℃ to 45℃
Size:281*268*173mm
Weight: 8.9kg

Feature:
PICO-3 3000nW laser projector
1.Pico series: laser module entirely manufactured in Europe.
2.Fully sealed optical section, IP67 waterproof seal power driver
3.Controller pannel for brightness, size X/Y, invert X/Y.

My Ray X3 Laser Show Projectors Pico Series
You can use My Ray X3 laser show projector for night club laser project and 3D laser man show.
You can use this laser projector for 3D laser man show, but you needs control via PHOENIX Laser Show Controller and a laser screen.

My Ray X3 laser show projector

The My Ray X3 is suitable for small and middle venues (site area<300㎡,height<8m), which use the laser component imported from Europe, give good quality, performance and stability projection.
Because using all diode lasers, laser design integration, its brightness and effect even beyond the conventional 5W Chinese-made laser lights.
Self-developed laser ILDA-AMP has been pre-installed inside, it allows you to use longer ILDA signal lines to control, interference and graphics jitter will not occur.

My Ray X3 laser show projector front view

The My Ray X3 laser show projector comes with a completely new designed compact housing, which is light weight and has a stable bracket. The bracket allows for different mounting positions: a hanging as well as a standing installation is possible - ideal for mobile DJs and temporary laser shows, but also for fixed installations at a truss or at the ceiling.
Thanks to major technological breakthrough, we greatly improve the air volume with heat radiation substitute to the original dust gauze design, while the My Ray X3 will get rid of dust gauze jam.
The optical bench by suspension design, make the optical light mixing effect better, more stable. Usual transport and use will not have any impact on the optical light mixing module, even the transport collision and rolling, hardly affect the optical system. You can rest assured that the equipment hanging up, hanging side and upside down.

Pico-3 the laser show projector Pannel

Design for ILDA Standard. But you also can control by DMX or SD-card player. You can use the potentiometer to adjust the Laser projector output brightness for each color and X/Y size. It have a very good design is the convert X/Y button.
Use it you can very fast to setup the X or Y image mirror.

Suitable case：Venues, Laser man show, Wedding etc.

03.May 2018